Published on *PNG 520: Phase Behavior of Natural Gas and Condensate Fluids* (https://www.e-education.psu.edu/png520)

P-x and T-x diagrams are quite useful, in that information about the compositions and relative amounts of the two phases can be easily extracted. In fact, besides giving a qualitative picture of the phase behavior of fluid mixtures, phase diagrams can also give quantitative information pertaining to the amounts of each phase present, as well as the composition of each phase.

For the case of a binary mixture, this kind of information can be extracted from P-x or T-x diagrams. However, the difficulty of extracting such information increases with the number of components in the system.

At a given temperature or pressure in a T-x or P-x diagram (respectively), a horizontal line may be drawn through the two-phase region that will connect the composition of the liquid (x_{A}) and vapor (y_{A}) in equilibrium at such condition — that is, the bubble and dew points at the given temperature or pressure, respectively. If, at the given pressure and temperature, the overall composition of the system (z_{A}) is found within these values (x_{A} < z_{A} < y_{A} in the T-x diagram or y_{A} < z_{A} < x_{A} in the P-x diagram), the system will be in a two-phase condition and the vapor fraction (α_{G}) and liquid fraction (α_{L}) can be determined by the lever rule:

$${\alpha}_{G}=\frac{{z}_{A}-{x}_{A}}{{y}_{A}-{x}_{A}}$$ (5.1a)

$${\alpha}_{L}=\frac{{y}_{A}-{z}_{A}}{{y}_{A}-{x}_{A}}$$ (5.1b)

Note that α_{L} and α_{G} are not independent of each other, since α_{L} + α_{G} = 1. Figure 5.5 illustrates how equations (5.1) can be realized graphically. This figure also helps us understand why these equations are called “the lever rule.” Sometimes it is also known as the “reverse arm rule,” because for the calculation of α_{L} (liquid) you use the “arm” within the (y_{A}-x_{A}) segment closest to the *vapor*, and for the vapor calculation (α_{G}) you use the “arm” closest to the *liquid.*

At this point you will see clearly why we needed to make a clear distinction among “x_{i}” and “y_{i}” and “z_{i}”. Expressions (5.1) can be derived from a simple material balance. Can you prove it? [*Hint: *The number of moles of a component “i” per mole of mixture in the liquid phase is given by the product “xiα_{L}”, while the number of moles of “i” per mole of mixture in the gas is given by “yiα_{G}”. Since there are “z_{i}” moles of component “i” per mole of mixture, the following must hold: ${z}_{i}={x}_{i}{\alpha}_{z}+{y}_{i}{\alpha}_{G}$. Can you proceed from here?]